Filter
Top Products
3-6 WM-4T1i Module Installation and User Guide
Configuring PPP and MLPPP
Monitoring PPP/MLPPP Links
The following commands monitor the status of the PPP and MLPPP links.
PPP/MLPPP Configuration Examples
The following examples show how to configure multilink groups.
Configuring a Bridged PPP/MLPPP Link Example
The following example shows how to configure a BCP-encapsulated multilink group.
BCP is the default encapsulation, so it is not explicitly included in this example. The
config ports t1 clocksource command is included to show where you might need
to configure the T1 parameters for your link. Each T1 port in the multilink group will
restart multilink <groupname> Restarts multilink group. Configuration changes
made to an enable multilink group will not take
effect until the group is restarted.
unconfig ppp port <portlist> Resets the port to the default PPP
configuration; no authentication and BCP
encapsulation.
Table 3-2: PPP/MLPPP Show Commands
Command Description
show multilink <groupname> Displays the configuration of the multilink
group.
show multilink [<groupname>] stats {detail} Displays multlink group statistics.
show multilink [<groupname>] t1 alarms {detail} Displays T1 alarm status for multilink groups.
show multilink [<groupname>] t1 errors
[near-end | far-end] [totals | intervals | current]
Displays T1 error statistics for a multilink
group.
show ppp {<portlist>} {detail} Shows PPP configurations.
show accounts pppuser Show the PPP accounts on the switch.
Table 3-1: PPP/MLPPP Configuration Commands (continued)
Command Description