Filter
Top Products
VersaTools
®
MTP DA4 and MTP DA8 • Quick Start Guide
Quick Start Guide
VersaTools
®
MTP DA4 and MTP DA8
Install and set up the MTP DA as follows:
Step 1
Turn all of the equipment off and disconnect it from the power
source.
Step 2
If the DA is part of a system that includes an MTP T 15HD A or
MTP 15HD RS transmitter, check, and if necessary, reconfigure the
serial data/audio termination and mute jumpers inside the DA. See
Termination and Mute Jumpering — MTP 15HD Systems Only, on page 4.
Step 3
Connect a twisted pair (TP) cable from an MTP
transmitter, MTP SW switcher, or VTT
transmitter to the A/V Input RJ-45 connector.
See the TP connector table at right to terminate
the cable.
Step 4
Connect up to 4 or 8 TP cables between the
DA’s A/V Outputs connectors and an MTP or
VTT receiver that is compatible with the
transmitted signal. See the TP connector table
at right to terminate the cable.
Step 5
If desired, connect a contact closure control to the Output Mute
captive screw connector shown below. Each numbered pin is
assigned to a DA output (pin A is assigned to all DA outputs). When
you short and latch a pin or pins to ground, the DA mutes the
associated twisted pair output(s).
1
2
3
4
5
6
7
8
White-green
Green
White-orange
Blue
White-blue
Orange
White-brown
Brown
TP connector
Pin Wire color
TIA/EIA 568 A
1234 5678A
MTP DA8
Output Mute Connector
1234A
MTP DA4
Output Mute Connector
Out #3
Pin
CC
Function
1Out #1 Mute output #1
2Out #2 Mute output #2
3Mute output #3
4Out #4 Mute output #4
5Out #5 Mute output #5
6Out #6
Out #7
Out #8
Out All
Mute output #6
Mute all
Mute output #7
Mute output #8
7
8
A
GndGround
QS-1