Extron electronic MVX 88 Switch User Manual


 
Optimizing the Audio
Each individual input audio gain can be adjusted within a range of -18 dB to +10 dB to
eliminate noticeable volume differences between sources and to achieve the best headroom
and signal-to-noise ratio. Adjust the audio level as follows:
1. Connect audio sources to all desired inputs and connect the audio outputs to output
devices such as audio players. See “Video and Audio Input Connections” and
Video and Audio Output Connections” in the “Installation” section. For best
results, wire all of the inputs and the outputs balanced when possible.
2. Power on the audio sources, the switcher, and the audio players.
3. Apply audio signals to all inputs to be optimized.
4. In Audio Setup mode (see “Adjusting Input Audio Gain and Attenuation,” on
page 23) select among the inputs while observing the front panel Power LED. The LED
blinks at a rate that corresponds to the highs and lows of the audio signal.
5. As necessary, adjust the audio gain of each input so that the Power LED blinks frequently
for all selected inputs. If the LED is lit most of the time, the level is probably too high; if
the LED rarely flashes, the level is too low.
As an alternative:
If necessary, temporarily set the output 1 level to the consumer (-10 dBV) level (see the
Audio output level SIS commands in the “Remote Operation” section).
Measure the output 1 audio level (in Audio Setup mode, the selected input is tied to
output 1) with test equipment, such as a VU meter, or listen to the output 1 audio with
a critical ear.
Troubleshooting
This section gives recommendations on what to do if you have problems operating the
MVX Series switcher.
1. Ensure that all devices are plugged in and powered on. The switcher is receiving power
if the power LED is lit.
2. Ensure an active input is selected for output on the switcher.
3. Ensure that the proper signal format is supplied.
4. Check the cabling and make corrections as necessary.
5. Call the Extron S3 Sales and Technical Support Hotline if necessary. See the last page of
this guide for the phone number in your region of the world.
MVX 44 / 48 / 84 / 88 VGA Matrix Switchers • Operation 31