Filter
Top Products
Extron • System 4
xi
Switcher Series • User’s Manual • P/N 68-412-02 Rev. A
Hughes Installation Configuration and Connections
(Note: Information depends on
S
y
stem 4 setup.
)
(See note.)
(See note.)
(See note.)
(See note.)
[System 4 model and software
version displayed here]
Page 1
}
Connecting System 4xi to Hughes/JVC Projectors
If the System 4xi is already configured for a Hughes/JVC projector, go to step 4.
If it is not set up correctly, it will be necessary to change switch settings on the
System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct
configuration.
1. Use the Front Panel to display the Information Menu to verify that the System 4xi
is already set up for the Hughes/JVC projector. Apply power to the System 4xi
and do the following:
a. Press
to display the MENU SELECT on the LCD screen.
b. Press
or to step to Menu 8.
c. Press
to select this menu.
d. Press
or to display the configuration. The example to the left is general,
yours will show the System 4xi model name, the software version and the
following information:
PRJ = HUGHES
PRJ BAUD = 19200
UNIT No.= 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 to remove the System 4xi cover and then go to
page 2-4 to set up the Main Controller board. Return to Step 3 (below) when the
configuration is correct.
Config Projector SW1: 1-2-3-4 SW2 SW3 SW4 SW5 SW6 Prj Cable Comm
as Adapter
✔ Hughes-JVC off-on-off-on 0 0 5 6 0 J15 26-467-01
3. Double-check your work and be sure the System 4xi cover is on securely.
4. Install the System 4xi in its place of operation (i.e. rack), but do not connect the
power cable.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Follow the correct cable connection diagram for your Hughes projector and
continue the installation.
5. The UNV ADP, “A” (26-467-01) has two 9-pin connectors, one male and one
female. Plug the 9-pin female connector onto the 9-pin male marked “Control
Out” (Port B) on the Hughes projector back panel.
SW1
ON
SW2
SW4
SW3
SW5
J15
3
4
1
2