Extron electronic P/N 68-412-02 Switch User Manual


 
Extron System 4
xi
Switcher Series Users Manual P/N 68-412-02 Rev. A
Hughes Installation Configuration and Connections
Page 5
SW1
ON
SW2
SW4
SW3
SW5
J15
3
4
1
2
Connecting System 4xi to Hughes-JVC DILA G1000/G10 Projectors
If the System 4xi is already configured for a Hughes-JVC DILA projector, go to
step 4. If it is not set up correctly, it will be necessary to change switch settings
on the System 4xi s Main Controller Board. Begin at Step 1 to verify the correct
configuration.
1. Use the Front Panel to display the Information Menu to verify that the System 4xi
is already set up for the Hughes-JVC DILA projector. Apply power to the
System 4xi and do the following:
a. Press
to display the MENU SELECT on the LCD screen.
b. Press
or to step to Menu 8.
c. Press
to select this menu.
d. Press
or to display the configuration. The example to the left is general,
your display will show the System 4xi model name, the software version and
the following information:
PRJ = HUGHES
PRJ BAUD = 19200
UNIT No.= 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 of the
System 4
xi
Users Manual
to remove the
System 4xi cover. Then go to page 2-4 and refer to the configuration below to
set up the Main Controller board. Continue with Step 3 (below) when the
configuration is correct.
Config Projector SW1: 1-2-3-4 SW2 SW3 SW4 SW5 SW6 Prj Cable Comm
as Adapter
Hughes/JVC DILA off-on-off-on 0 0 8 F 0 J15 26-467-01
3. Double-check your work and be sure the System 4xi cover is on securely.
4. Install the System 4xi in its place of operation (i.e. rack), but do not connect the
power cable.
__________ Changes in some switch configurations are not detected until the power is
removed at the AC cord, and then restored.
Refer to the following connection diagrams for your Hughes projector and
continue the installation. Use the UNV ADP A (26-467-01) provided by Extron.
}
(Note: Information depends on
S
y
stem 4 setup.
)
(See note.)
(See note.)
(See note.)
(See note.)
[System 4 model and software
version displayed here]