Extron electronic RGB 500 AKM Switch User Manual


 
Specifications, cont’d
RGB 500 AKM and RGB 560 AKM SpecificationsA-2
Specifications
Video
Gain ................................................ Unity (0.70V p-p), (0.725V p-p) 50% peaking, (0.75V p-p) 100% peaking
Bandwidth ..................................... 300 MHz (-3dB)
Video input
Number/signal type ................... 1 analog RGBHV, RGBS, RGsB, RsGsBs
Connectors
RGB 500 AKM
1 9-pin D male, MBC/LBC cable or buffer
RGB 560 AKM
1 15-pin HD female
Minimum/maximum levels ....... Analog ....... 0.3V to 1.5V p-p with no offset
Impedance .................................... 75 ohms or High Z, switchable (set to 75 ohms if no local monitor is
connected)
Horizontal frequency.................. Autoscan 15 kHz to 130 kHz
Vertical frequency ....................... Autoscan 30 Hz to 120 Hz
Return loss .................................... -30dB @ 5 MHz
Maximum DC offset .................... 4.0V
Video output
Number/signal type ................... 1 analog RGBHV, RGBS, RGsB
Connectors
All models ........................ 5 BNC female
RGB 560 AKM
1 15-pin HD female for buffered local monitor output
Minimum/maximum levels ....... 0.70V to 0.75V p-p with no offset and 0.7V p-p input
Impedance .................................... 75 ohms
Return loss .................................... -30dB @ 5 MHz
Sync
Input type ..................................... RGBHV TTL (±), RGBS TTL (-), RGsB 0.3V (-), RsGsBs 1.3V (-)
Output type .................................. RGBHV (±), RGBS(-), RGsB (-)
Input level ..................................... 2V to 5.5V p-p with ±0.3VDC offset (max.)
Output level .................................. 4V to 5V p-p
Input impedance .......................... 10 kohms
Output impedance ....................... 75 ohms
Max. input voltage ....................... 5.7V p-p
Max. propagation delay .............. 48 nS
Max. rise/fall time ....................... 3.5 nS
Polarity
AKM models ....................... RGBHV...................... Polarity follows input when RGBHV is input and the
sync polarity switch is set to Off. Sync polarity is
negative if the sync polarity switch is set to On.
RGBS, RGsB .............. Negative
Audio
Gain ................................................ Unbalanced 0dB, balanced +6dB
Frequency response .................... 20 Hz to 20 kHz, ±0.05dB
THD + Noise ................................. 0.03% @1 kHz, 0.3% @ 20 kHz at rated maximum output drive
S/N ................................................ >90dB at rated maximum output (14dBm), balanced
Stereo channel separation .......... >95dB @ 1 kHz to 20 kHz