Extron electronic SW12 VGA ARS Switch User Manual


  Open as PDF
of 41
 
Installation and Operation, cont’d
SW8/12 VGA Ars • Installation and Operation
2-4
Mounting under a desktop
Under-deskmountingrequirestheoptionalMBU1491U,under-deskmountingkit
(part #70-222-01).
MountanSW8/12VGAArsunderadesktopasfollows:
1. Installthemountingbracketsontheunit’ssideswiththeeightmachine
screws provided in the kit.
2
. Holdtheunit(withbracketsattached)againsttheunderside of the desk.
Markeachbracket'sholelocationontheundersideofthedesk.
3. Drill1/4"(6.4mm)deep,3/32"(2mm)diameterpilotholesfromthe
underside of the desk at the marked hole locations.
4
. Insertthefourwoodscrewsintothepilotholesandtightenuntil
approximately1/4"(6.4mm)ofthescrew'sheadisprotruding.
5. Installthemountingbrackets,withtheunitattached,overtheprotruding
screw heads.
6
. Slide the unit slightly to lock it in place.
7. Tighten all four screws to secure it in place.
#8 Screw
(4 Plcs)
Each Side
Optional Furniture Mountin
g Bracket
Mounting Screws
(2 Plcs)
Each Side
Figure 2-2 — Mounting the switcher under a desktop
 previous next