Extron electronic SW12 VGA ARS Switch User Manual


  Open as PDF
of 41
 
2-9
SW8/12 VGA Ars • Installation and Operation
Audio output connections
Theswitcherhavetwo3.5mm5-polecaptivescrewaudiooutputports.
TheFixedportdeliversaxedvolume,stereobalanced/unbalancedaudiooutput.
The Variable port delivers a variable volume, stereo balanced/unbalanced audio
output.Thevolumerangeis0(-84dB)through100(0dB).Thedefaultvolume
settingis100(0dB).VolumeiscontrollableonlyviatheRS-232port.
RS-232
SW12 VGA Ars
1
2
FIXEDVARIABLE
LRLR
O
U
T
P
U
T
S
Audio output ports
Figure 2-10 — Audio output ports
Wire the captive screw connectors as shown below.
C
Connect the sleeve to ground (_). Connecting the sleeve to a
negative (-) terminal will damage the audio output circuits.
Do not tin the wires!
Unbalanced
Stereo Output
Tip
NO GROUND HERE.
Sleeve(s)
Tip
NO GROUND HERE.
Balanced
Stereo Output
Tip
Ring
Tip
Ring
Figure 2-11 — Captive screw connectors
N
A balanced audio output provides a +6 dB gain. An unbalanced audio output
provides a 0 dB gain.
Remote control connection
AnRS-232serialcontrolportattherightedgeoftherearpanelisusedforcomputer
orinfrared(IR)remotecontrolofthedevice.Theswitcher’srmwarecanbe
upgradedthroughtheRS-232port.Seechapter3,“OperationandControl”.
TheRS-232portcommunicationsprotocolsare:9600baud,8databits,1stopbit,
no parity, and no flow control.
IRremotecontrolrequiresuseoftheIR102RemoteControlKit(part#70-224-01)
Forcomputerorinfraredremotecontrol,onlypins2(transmitdata),3(receive
data),and5(ground)arerequired.Disconnectallotherconductorsinthe
attachment cable for proper operation.
RS-232
SW12 VGA Ars
1
2
FIXED VARIABLE
LRLR
O
U
T
P
U
T
S
RS-232 control port
DB9 Pin Locations
Female
51
96
Figure 2-12 — RS-232 control port
 previous next