Filter
Top Products
d
Videoinput Two female BNC connectors on pigtails used to
input either S-video (yellow-chroma, white-luma) or composite
video (white only).
For composite input, connect the composite cable to the white
video input cable.
For S-video input
connect the luma cable
to the white video
input and the chroma
cable to the yellow
video input.
e
MTPoutput One female RJ-45 connector to output the MTP A/V
signal to the touchpanel.
The TP cable connecting the TLP VIM output to the MTP input of
the touchpanel is standard UTP or STP Cat 5 or better cable. The
ends may be terminated using either TIA/EIA 568A or TIA/EIA 568B
but both ends must use the same standard.
Reserved
Reserved
Mono audio+
Video–
Mono audio–
Reserved
Reserved
MTP Signal
Composite
Video+
5
Pin
1
2
3
6
7
8
4
Wire Color
White-green
Green
White-orange
White-blue
Orange
White-brown
Brown
Wire Color
T568A T568B
White-orange
Orange
White-green
White-blue
Green
White-brown
Brown
Blue Blue
Insert
TP Wires
Pins:
NOTE: When using Enhanced Skew-Free™ A/V cable, use
the TIA/EIA T568A standard only.
12345678
MTP Signal
S-video
Chroma+
Chroma–
Mono audio+
Luma–
Mono audio–
Reserved
Reserved
Luma+
CAUTION: The TLP VIM output uses higher voltages than a LAN. Inputting
those voltages on a LAN communications port may damage the
connection.
Operation
No setup or configuration is required. Once cabling is complete,
apply power to the connected equipment and TLP VIM. The unit is
ready for operation.
Figure 5. VideoInputs
POWER
12V
0.5A MAX
INPUT
AUDIO
VIDEO
OUTPUT
Yellow: Chroma
White: Luma or
Composite
6 TLPVIM•InstallationandOperation