Filter
Top Products
Firmware Version
This user guide is based on v3.8 firmware. You can check for newer firmware releases and
user guide updates by visiting our web site at www.extron.com/downloads.
TIP: To check which version of firmware is currently installed, see “Upgrading
Device Firmware.”
Product Range
There are three VN 200 Matrix products. These units are compatible with each other, but
there are some feature limitations and differences between each variant.
VNC 200 DVI-I — Codec
This unit:
• May be configured as either an encoder or a decoder
• Supports the full use of remote keyboard and mouse
• Remote and RS-232 ports are enabled
CODEC
12V DC
5A MAX
POWER
1 — LAN — 2
IN
OUT/
LOOP
AUDIO
SPDIF
REMOTE
TO PCIN
INDVI-IOUT/LOOP
RS-232
OVER LAN
Figure 1. VNC 200 DVI-I, CODEC — Back Panel
VNE 200 DVI-I — Encoder Only
The VNE 200 is an encoder-only device and is compatible with the other products in the
VN-Matrix family.
NOTE: The VNE 200 does not support:
• Mouse and keyboard operation
• RS-232 client / server operation
Encoder
12V DC
5A MAX
POWER
1 — LAN — 2
IN
OUT/
LOOP
AUDIO
SPDIF
REMOTE
TO PCIN
INDVI-IOUT/LOOP
RS-232
OVER LAN
Figure 2. VNE 200 DVI-I, Encoder — Back Panel
VN-Matrix 200 Series • Introduction 2