Filter
Top Products
YCS 100 • Installation and Operation
Installation and Operation, cont’d
2-8
YCS 100 • Installation and Operation
2-9
• For the YCS 100 unit, use two of the supplied
4-40 x 3/16" screws in opposite (diagonal) corners to
secure the device to the bracket.
For the YCS power supply, use the two included tie
wraps to strap the power supply to the bracket.
N
The PMK 300 has a hole in the bottom plate that allows
the projector pole to be inserted through the center of
the plate, rather than outside of the plate (see fi gure 2-9,
below). To install the PMK 300 in this confi guration,
slide the bracket up from the bottom of the pole before the
projector is installed on the pole.
U-Bolt
Extron
PMK 300
Multi-product Projector
Mount Kit
Bracket
Brace
Figure 2-9 — Projector-mounting the YCS 100
using the PMK 300 with the projector pole passing
through the center
Using the PMK 300 Projector Mount Kit
The PMK 300 Multi-Product Projector Mount Kit (#70-374-01)
mounts up to three quarter-rack width products to a projector
ceiling mount pole. The YCS 100 can be mounted above the
display device with the front panel facing either down or up.
The quarter rack width plate can also be used to mount the YCS
external desktop power supply.
Follow these steps to projector-mount the YCS 100 using the
PMK 300:
1. If necessary, remove the feet from the bottom of the YCS.
2. Mount the YCS to one of the bracket’s three mounting
plates. It can be vertically mounted facing either up or
down, whichever you prefer. See fi gure 2-8, below.
Extron
PMK 300
Multi-product
Projector
Mount Kit
U-Bolt
Bracket
Brace
Figure 2-8 — Projector-mounting the YCS 100 using
the PMK 300 Projector Mount Kit
• On the side mounting plates, the YCS is typically
mounted on the outside of the bracket.
On the front mounting plate, the device is typically
mounted on the inside of the bracket.