Filter
Top Products
FS
-
8700
-
82 Carrier DataLink
Page
29
of
31
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web:www.fieldserver.com
Tel: (408) 262-2299 Fax: (408) 262-9042 Toll_Free: 888-509-1970 email: support@fieldserver.com
Appendix D. Driver Error Messages
The driver reports information and errors in the form of messages printed to the error log. Those
messages marked with a * are only printed once even if they occur repeatedly.
Error Message Explanation
Carrier:#1 FYI. The
MapDesc called <%s> is too
short
The length of the Map Descriptor used to expose driver
statistics is too short. Set to at least 1000. This message may
be ignored
§
.
Carrier:#2 FYI. You could
have used a MapDesc called
<%s> to expose diagnostic
info.
This message is a prompt and may be ignored. Read
Appendix C.1 for more information.
Carrier:#3 Err. Illegal
Node_ID=%d Valid=1..15
Valid node numbers are in the range 1 to 15 inclusive. Read
sections 4.3 or 5.3 for more information.
§
Carrier:#4 FYI. Address has
no meaning. Best set to 1
MapDesc=<%s>
You can ignore this message. The address parameter has no
meaning in the configuration of this driver. Remove the
parameter from the configuration or set its value to 1
§
Carrier:#5 Err. For write, set
length to 1. MapDesc=<%s>
Carrier:#6 FYI. Field Name
Blank. Assumed
'EVERYTHING'.
MapDesc=<%s>
If the Field_Name parameter is left unspecified then the driver
assumes you intend reading the whole table by filling in the
Field_Name with the keyword EVERYTHING. Suppress this
message by specifying the Field_Name .
§
Carrier:#7 Err. Table name
required. MapDesc=<%s>
Every Map Descriptor for this driver requires that you specify a
table name. Section 4.4.2 and Appendix A.1 provide additional
information.
§
Carrier:#8 Err. Length
required. MapDesc=<%s>
The length parameter must be set in the configuration file to a
value greater than zero. Refer to Appendix A.3.
§
Carr:#9 FYI. Duplicate
state=<%s>. Value has been
updated from=%d to=%d
You have specified a discrete state word in the configuration
file which is a duplicate of one already in the list. The driver
uses the new value, thus changing the values for the driver’s
default discrete state words. You can ignore this message.
Carr:#10 Err. No space.
Driver rejects value
state=<%s> value=%d
The driver has limited space to store discrete state keywords
added in the configuration file. The maximum is 150 words
including the driver’s defaults. Remove some of the keywords
you have added to the configuration file.
§
Carr:#11 FYI. User added
value state=<%s> value=%d
You can ignore this message; it is for information only. Each
time a new discrete state word is added to the driver from the
configuration file, the driver reports the new word and its value.
Carr:#12 Err. Length too
short to store all. MD=<%s>
The read table command resulted in more variables being
returned than you have reserved space for (with the length
parameter). Increase the length parameter
§
.
Carrier:#13 FYI. Diagnostic
send error #1 response.
Carrier:#14 FYI. Diagnostic
cancelled slave response
These messages are for FieldServer engineers. If printed in
the error log please call FieldServer support and report the
message.
§
Correct the error by editing the configuration CSV file, downloading the corrected file to the FieldServer
and then resetting the FieldServer.