Filter
Top Products
14
Part Names and Functions
To insure safe operation, please observe the following precautions :
● Use (2) AA, UM3 or LR6 type alkaline batteries.
● Replace two batteries at the same time.
● Do not use a new battery with a used battery.
● Avoid contact with water or liquid.
● Do not expose the remote control to moisture, or heat.
● Do not drop the remote control.
● If a battery has leaked on remote control, carefully wipe case clean and install new batteries.
● Risk of explosion if battery is replaced by an incorrect type.
● Dispose of used batteries according to the instructions.
Press the lid downward
and slide it.
Remove the battery
compartment lid.
Slide the batteries into
the compartment.
Replace the compartment
lid.
Two AA size batteries
For correct polarity (+ and
–), be sure battery
terminals are in contact
with pins in compartment.
12 3
Remote Control Battery Installation
This projector has eight different remote control codes (Code 1-Code 8). Switching remote control codes prevents remote
control interference when operating several projectors or video equipment at the same time. Change the remote control
code for the projector first before changing that for the remote control. See “Remote control” in Setting on page 46.
With holding down the MENU button, press the IMAGE
button. The code switches sequentially for one pressing the
IMAGE button. (See the list below.)
1
To initialize the remote control code, slide the
RESET/ON/ALL-OFF switch to RESET, and then to ON. The
initial code is Code 1. (p11)
2