Filter
Top Products
68 05-16000-0082-20050115 Fortinet Inc.
Vulnerability reports Reports
3 Set the following:
• “Selecting report result parameters” on page 68
• “Selecting plug-ins” on page 68
• “Selecting the scan targets for the report” on page 69
• “Choosing the report destination and format” on page 71.
4 Select Run now.
Selecting report result parameters
Report results parameters define how the FortiLog unit displays the vulnerability
report results. Report results parameters include:
• the specific device or all device logs submitted to the FortiLog unit.
• the device IP addresses or alias names.
Figure 37: Vulnerability report parameters
To define report result parameters
1 Go to Reports > Config > Vulnerabilities.
2 Select new.
3 Enter a report name and select OK.
4 Configure the following options:
5 Select Apply.
Selecting plug-ins
Select the port scans the FortiLog unit will perform on the selected device(s).
For all devices Select to generate the report for all devices.
Per device Select to generate a separate report for each device.
Resolve Host
Names
Select to display host names by name rather than IP addresses. For details
on configuring IP address host names see “Defining IP aliases” on page 55.
Resolve Service
Names
Select to display network service names rather than port numbers. For
example, HTTP rather than port 80.