Filter
Top Products
45
Using the Databank
Using a Password
You can use a password to
prevent unauthorized access to
the databank. Warning! Always
write the password in a safe,
separate location. If you lose or
forget the password, you will be
able to use the databank again
only by removing the batteries
from your BOOKMAN, which will
permanently erase all the
information stored in the
databank.
1.Press and DATEN (F2).
2.Highlight Set password and
then press EINGABE.
3.Type a password of up to
eight characters and press
EINGABE.
Use to move the cursor;
use to delete.
4.Press C to confirm or
CLEAR to cancel the
password.
The password you set will be
requested the first time that
the databank is used during a
session.
5.To change the password,
repeat Steps 1-4.
To remove a password, press
EINGABE at the blank
password screen.
Using the Databank