Filter
Top Products
1-10 C120-E361-04EN
CHAPTER 1 RCI Build Procedure
7 Execute the setrci -c addconfig command on main unit B to expand the RCI
configuration.
8 Display the RCI status by executing the setrci -c statcommand on main unit A.
9 Verify that the added main unit is incorporated.
1.3.5 Connection of RCI
According to the following procedure, connect different units with RCI cables by
using a daisy-chain connection.
1 Prepare RCI branching connectors and RCI terminating resistors.
All of them are supplied with the main unit.
2 Connect the main unit and I/O units with RCI cables (see Figure 1.9 and
Figure 1.10.)
1 Connect the RCI branching connector (1) to the RCIport on an XSCF unit of the
main unit.
2 Connect the RCI branching connector and the RCI port of an I/O unit with an RCI
cable (2) by using a daisy-chain connection.
XSCF> setrci -c set 2
The command completed successfully
XSCF> setrci -c addconfig
The command completed successfully
XSCF> setrci -c stat
HOST
address 000102ff
Active
LIST
address pwr alm I/F sys-phase ctgry dev-cls sub-cls tm-out
000101ff OFF - ACT -- host 0001 0b -
000102ff OFF - ACT -- host 0001 0b -
003001ff OFF - ACT -- disk 0400 04 -
003002ff OFF - ACT -- disk 0400 04 -
The command completed successfully