Filter
Top Products
3
FTP-633MCL400/FTP-623DCL002
For print head
4.2 to 8.5 VDC (4 or 5 Ni-Cd or Ni-MH batteries, equivalent to 2 Li-ion)
Approximately 3.0 A (peak value, 7.2 V, 100% printing ratio)
For motor
4.2 to 8.5 VDC (4 or 5 Ni-Cd or Ni-MH batteries, equivalent to 2 Li-ion)
Average 0.7 A or less
For logic 5 VDC ± 5%, 0.15 A
Weight Mechanism: approximately 84 g. Interface board: approximately 60 g
Printer mechanism
Dimensions 85 (W) × 49 (D) × 20 (H) mm (excluding knob, lever, and flexible PC board)
Interface board Dimensions 108 (W) × 91 (D) × 18 (H) mm
Pulse durability : 1 × 10
8
pulse/dot (using Fujitsu Takamisawa's standard
driving method)
Wear resistance: 50 km (at 25% printing ratio)
Operating temperature +5 to +40°C*
3
Operating humidity 20 to 85% RH (no condensation)
Storage temperature –20 to +60°C (excluding paper)
Storage humidity 5 to 95% RH (no condensation)
Head temperature By thermistor
Detection Paper out/Mark detect By photointerrupter (command set)
Voltage By micro controller
Head-up By microswitch
Paper width 70 mm
1 ply (roll) : FTP-030PG021 Long life (roll) : FTP-030PR202
2 ply (TCC) : FTP-030P8021
SpecificationsItem
(Continued)
Operating
voltage
Thermal head life
Environmental
conditions
+0
–1
Recommended thermal sensitive paper
*1: Character composition for single density reduced mode is the same as for single density standard mode.
*2: The data to be printed is automatically read out by the printer driver equipment memory (host system frame
memory). The communication is parameter transfer.
*3: Temperature range for guaranteed printing density. It can be operated in the range of 0 to +40°C.