Filter
Top Products
Capacity on Demand (COD) Administration 11
▼ To Enable, Increase, or Decrease Headroom
1. Log in to the XSCF console with platadm privileges.
2. Execute the showcod command with no options.
For example:
3. Type the setcod command, specifying headroom.
For example:
where headroom can be a number from 1 to 4. For example:
4. Verify the headroom quantity is correct by executing the showcod command.
For example, if you entered 4 as the headroom number, the output would be
similar to:
Note – When headroom is in use, the XSCF console displays periodic warning
messages requesting installation of new COD permits. The warning messages
continue to be displayed until new keys are installed or headroom is no longer in
use.
XSCF> showcod
Chassis HostID: 80e3e446
PROC Permits installed: 10
PROC Headroom Quantity: 0
PROC Permits reserved for domain 0: 4
PROC Permits reserved for domain 1: 0
PROC Permits reserved for domain 2: 0
PROC Permits reserved for domain 3: 0
XSCF> setcod headroom
XSCF> setcod 4
WAARNING: Using headroom requires you to install key(s) within 30
days. Do you agree? [y|n]: y
XSCF> showcod
Chassis HostID: 80d88800
PROC Permits installed: 8
PROC Headroom Quantity: 4
...