Filter
Top Products
C141-E035-01EN5 - 2
c) Be careful not to give excess pressure to the PCAs and interface connector when removing
the drive from the antistatic bag.
d) Do not remove the sealing label or cover of the DE and screws.
(3) Installation
a) Do not attempt to connect or disconnect connections when power is on. The only pin
settings that may be altered are pins 9, 10 (Write Protect) in CN2.
b) Do not move the drive when power is turned on or until the drive completely stops (for 30
seconds) after power is turned off.
(4) Packaging
a) Store the drive in an antistatic vinyl bag with a desiccant (silica gel).
b) It is recommended to use the same cushions and packages as those at delivery. If those at
delivery cannot be used, use a package with shock absorption so that the drive is free from
direct shocks. In this case, fully protect the PCAs and interface connector so that they are
not damaged.
c) Indicate "This Side Up" and "Handle With Care" on the outside of the package so that it is
not turned over.
(5) Delivery
a) When delivering the drive, provide packaging and do not turn it over.
b) Minimize the delivery distance after unpacking and avoid shocks and vibrations with
cushions. For the carrying direction at delivery, use one of the mount allowable directions
in Subsection 4.2.2 (vertical direction is recommended).
(6) Storage
a) Provide vaporproof packaging for storage.
b) The storage environment must satisfy the requirements specified in Subsection 2.1.3 when
the drive is not operating.
c) To prevent condensation, avoid sudden changes in temperature.