Filter
Top Products
A-2 C141-E201
A.1 Setting Terminals (on NP model only)
Table A.1 CN2 setting terminal (on NP model drives only)
Pins
Setting item
1 - 2 3 - 4 5 - 6 7 - 8 9 - 10
Setting contents
Open Open Open (Open)
SCSI ID #0 (Common to 8-bit and 16-bit SCSI)
Short Open Open (Open)
SCSI ID #1 (Common to 8-bit and 16-bit SCSI)
Open Short Open (Open)
SCSI ID #2 (Common to 8-bit and 16-bit SCSI)
Short Short Open (Open)
SCSI ID #3 (Common to 8-bit and 16-bit SCSI)
Open Open Short (Open)
SCSI ID #4 (Common to 8-bit and 16-bit SCSI)
Short Open Short (Open)
SCSI ID #5 (Common to 8-bit and 16-bit SCSI)
Open Short Short (Open)
SCSI ID #6 (Common to 8-bit and 16-bit SCSI)
Short Short Short (Open)
SCSI ID #7 (Common to 8-bit and 16-bit SCSI)
Open Open Open Short SCSI ID #8 (16-bit SCSI only)
Short Open Open Short SCSI ID #9 (16-bit SCSI only)
Open Short Open Short SCSI ID #10 (16-bit SCSI only)
Short Short Open Short SCSI ID #11 (16-bit SCSI only)
Open Open Short Short SCSI ID #12 (16-bit SCSI only)
Short Open Short Short SCSI ID #13 (16-bit SCSI only)
Open Short Short Short SCSI ID #14 (16-bit SCSI only)
SCSI ID
Short Short Short Short
SCSI ID #15 (16-bit SCSI only) (*)
Open Write operation is enabled. (*) Write protect
Short Write operation is disabled.
Pins
Setting item
11 - 12 13 - 14 15 - 16 23 - 24
Setting contents
Motor start mode Open Started by the START/STOP command
Short Started by turning the power supply on (*)
Force Narrow Open Width of 16-bit bus (*)
Short Width of 8-bit bus
Force Single Ended Open Follows DIFFSNS signal level on SCSI bus (*)
Short Single-Ended mode
Terminating power supply Open Does not supply terminating resistor power to SCSI BUS
Short Supply terminating resistor power to SCSI BUS (*)
* Setting at factory shipment
Note:
See the description of Section 5.3 for details of the setting requirements and notes.