Fujitsu MAT3300NC/NP Computer Drive User Manual


 
C141-E201 v
Important Alert Items
Important Alert Messages
The important alert messages in this manual are as follows:
A hazardous situation could result in minor or moderate personal injury if the
user does not perform the procedure correctly. This alert signal also indicates
that damages to the product or other property may occur if the user does not
perform the procedure correctly.
Task Alert message Page
Data loss
The drive adopts Reed-Solomon code for ECC.
The sector-data is divided into 3 interleaving sectors, and ECC is
performed in each sector where the maximum number of errors
(up to 9 byte) can be corrected. [Total maximum byte: 9 byte
×
3
( interleave) = 27 byte]
If the error of read sector keeps allowable error byte number,
correction is performed.
However, if error byte exceeds its allowable number, correction
may not be performed properly.
Hot temperature
To prevent injury, do not handle the drive until after the device has
cooled sufficiently after turning off the power. The DE and LSI
become hot during operation and remain hot immediately after
turning off the power.
Data loss
1. The user must not change the setting of terminals not described
in this section. Do not change setting status set at factory
shipment.
2. Do not change the setting of terminals except following setting
pins during the power is turned on.
Write protect: CN2 9-10 (NP model only)
3. To short the setting terminal, use the short plug attached when
the device is shipped from the factory.
2-5
5-1
5-5
Mounting Installation
Damage
1. Make sure that system power is off before connecting or
disconnecting cables.
2. Do not connect or disconnect cables when power is on.(except
NC model)
5-12