Filter
Top Products
3 Flash On-Board Programming
There are two ways to program the on-chip Flash of MB9BF506 series MCU: UART On-
Board Programming and USB On-Board Programming.
3.1 On-Board Programming via UART
First check the hardware setting as introduced by section 2.3.
Install the UART programmer: PCWFM3_V01L01. (It can be downloaded on the web)
Open it, set the parameter as shown in following figure, and select Hex file.
Figure 3-1: UART Programmer Overview
Click Full Operation.
Figure 3-2: Press Reset Button
Press reset key in the board, and the programming will start.
Figure 3-3: Start Programming
10