Filter
Top Products
Index
C141-E042-01EN IN-5
Read/write preamplifier 4-9
RECALIBRATE 5-28
Recovery, write/read 4-19
Register, command block 5-8
Register, control block 5-13
Register, I/O 5-6
Reliability 1-8
Requirement, power 1-5
Reset 5-79
Reset timing 5-80
Response to diagnostic command 6-6
Response to hardware reset 6-4
Response to power-on 6-2
Response to software reset 6-5
Ripple 1-5
S
SA area 4-18
Sector Count register 5-9
Sector Number register 5-9
Sector servo configuration 4-16
Sector slip processing 6-12
SECURITY DISABLE PASSWORD 5-59
SECURITY ERASE PREPARE 5-60
SECURITY ERASE UNIT 5-61
SECURITY FREEZE LOCK 5-62
SECURITY SET PASSWORD 5-64
SECURITY UNLOCK 5-66
SEEK 5-29
Seek operation 4-20
Seek to specified cylinder 4-15
Self-calibration 4-7
Self-calibration content 4-7
Self-diagnosis 1-3
Sensing and compensating for external force
4-7
Sequence, operation 4-7
Sequence, power-on 4-6
Sequence, power on/off 1-6
Sequential command 6-17
Sequential hit 6-19
Sequential read 6-17
Service area 3-6
Service life 1-9
Servo A 4-19
Servo B 4-19
Servo burst capture 4-17
Servo burst capture circuit 4-17
Servo C 4-19
Servo circuit 4-4
Servo control 4-14
Servo control circuit 4-14
Servo D 4-19
Servo format, data-surface 4-18
Servo frame format 4-18
Servo mark 4-19
SET FEATURES 5-38
SET MULTIPLE MODE 5-40
Setting, CSEL 3-11
Setting, factory default 3-10
Setting, jumper 3-9
Setting, master drive 3-10
Setting, slave drive 3-10
Shock 1-8
Signal, interface 5-2
Signal assignment on connector 5-2
Single word DMA data transfer 5-78
Single word DMA data transfer timing
5-78
Slave 1-3
Slave drive setting 3-10
SLEEP 5-51
Sleep mode 6-11
SMART 5-53
Spare area 6-12
Specification, acoustic noise 1-7
Specification, cable connector 3-8
Specification, environmental 1-7
Specification, interface 5-1
Specification summary 1-4
Spindle 4-3
Spindle motor 2-3
Spindle motor control 4-17, 4-20
Spindle motor control circuit 4-17
Spindle motor driver circuit 4-4
Spindle motor start 4-15
SRST 5-13
Stable rotation mode 4-21
Standard value, surface 3-5
STANDBY 5-49
STANDBY IMMEDIATE 5-50
Standby mode 6-10
Start, spindle motor 4-15
Start mode 4-20
Status at completion of command execution
5-8
Status flag 5-58
Status register 5-11
Structure, head 4-3
Subassembly 4-2
Surface standard value 3-5