Fujitsu MHD2021AT Computer Drive User Manual


 
5.3 Host Commands
C141-E050-02EN 5-45
This command is operated under the following conditions:
The command is issued in a sequence of the READ LONG or WRITE LONG
(to the same address) command issuance. (WRITE LONG command can be
continuously issued after the READ LONG command.)
If above condition is not satisfied, the command operation is not guaranteed.
At command issuance (I/O registers setting contents)
1F7
H
(CM)
0 0 1 1 0 0 1 R
1F6
H
(DH)
×
L
×
DV
Head No. /LBA [MSB]
1F5
H
(CH)
1F4
H
(CL)
1F3
H
(SN)
1F2
H
(SC)
1F1
H
(FR)
Cylinder No. [MSB] / LBA
Cylinder No. [LSB] / LBA
Sector No. / LBA [LSB]
01
xx
R = 0 with Retry
R = 1
without Retry
At command completion (I/O registers contents to be read)
1F7
H
(ST)
Status information
1F6
H
(DH)
×
L
×
DV
Head No. /LBA [MSB]
1F5
H
(CH)
1F4
H
(CL)
1F3
H
(SN)
1F2
H
(SC)
1F1
H
(ER)
Cylinder No. [MSB] / LBA
Cylinder No. [LSB] / LBA
Sector No. / LBA [LSB]
00 (*1)
Error information
*1 If the command is terminated due to an error, this register indicates 01.
(19) READ BUFFER (X’E4’)
The host system can read the current contents of the sector buffer of the device by
issuing this command. Upon receipt of this command, the device sets the BSY bit
of Status register and sets up the sector buffer for a read operation. Then the
device sets the DRQ bit of Status register, clears the BSY bit, and generates an
interrupt. After that, the host system can read up to 512 bytes of data from the
buffer.