Filter
Top Products
Interface
5-4 C141-E050-02EN
[signal]
[I/O]
[Description]
ENCSEL
I
This signal is used to set master/slave using the CSEL signal (pin 28).
Pins A and C Open: Sets master/slave by the MSTR signal
without using the CSEL signal.
Short: Sets master/slave using the CSEL signal.
The MSTR signal is ignored.
MSTR
I
MSTR, I, Master/slave setting
1: Master 0: Slave
RESET-
I
Reset signal from the host. This signal is low active and is
asserted for a minimum of 25
µ
s during power on.
DATA 0-15
I/O
Sixteen-bit bi-directional data bus between the host and the
device. These signals are used for data transfer
DIOW-
I
Signal asserted by the host to write to the device register or data
port.
STOP
I
DIOW- must be negated by the host before starting the Ultra
DMA transfer. The STOP signal must be negated by the host
before data is transferred during the Ultra DMA transfer. During
data transfer in Ultra DMA mode, the assertion of the STOP
signal asserted by the host later indicates that the transfer has been
suspended.
DIOR-
I
Read strobe signal from the host to read the device register or data
port
HDMARDY-
I
Flow control signal for Ultra DMA data In transfer (READ DMA
command). This signal is asserted by the host to inform the
device that the host is ready to receive the Ultra DMA data In
transfer. The host can negate the HDMARDY- signal to suspend
the Ultra DMA data In transfer.
HSTROBE
I
Data Out Strobe signal from the host during Ultra DMA data Out
transfer (WRITE DMA command). Both the rising and falling
edges of the HSTROBE signal latch data from Data 15-0 into the
device. The host can suspend the inversion of the HSTROBE
signal to suspend the Ultra DMA data Out transfer.
INTRQ
O
Interrupt signal to the host.
This signal is negated in the following cases:
−
assertion of RESET- signal
−
Reset by SRST of the Device Control register
−
Write to the command register by the host
−
Read of the status register by the host
−
Completion of sector data transfer
(without reading the Status register)
The signal output line has a high impedance when no devices are
selected or interruption is disabled.