Filter
Top Products
3.2 Mounting
C141-E050-02EN 3-5
(2) Frame
The MR head bias of the HDD disk enclosure (DE) is zero. The mounting frame
is connected to SG.
Use M3 screw for the mounting screw and the screw length should
satisfy the specification in Figure 3.3.
The tightening torque must not exceed 3 kgcm.
When attaching the HDD to the system frame, do not allow the
system frame to touch parts (cover and base) other than parts to
which the HDD is attached.
(3) Limitation of side-mounting
Do not use the center hole. For screw length, see Figure 3.3.
Note) These dimensions are recommended values; if it is not possible to
satisfy them, contact us.
Figure 3.3 Mounting frame structure
Screw
Screw
Details of B
Details of A
3.0 or less
3.0 or less
Frame of system
cabinet
Frame of system
cabinet
B
PCA
A
2
2.5
2.5
2.5
2.5
DE
Side surface
mounting
Bottom surface mounting