Filter
Top Products
6
2
1
Plug the system unit's power cable into the system unit (1) and then into the grounded mains
outlet (2).
■ Initial Switch-on: Software will be Installed
If the PC is connected to a network, the network protocol is required as well as the user and server
details. Contact your network administrator if you have any questions about these settings.
When you switch on your PC for the first time, the supplied software is installed and configured. You
should plan some time for this, as this process must not be interrupted.
CAUTION
Once the installation has been started the PC must not be switched off!
During installation the PC may only be rebooted when you are requested to do so!
Otherwise the installation will be not be performed correctly. If a fault occurs during the installation,
the contents of the hard disk must be completely restored.
You may need the licence number for Windows during the installation. This number is located on
a sticker on your PC.
Switching on monitor and PC
Switch the monitor on (see the operating manual for the monitor).
Switch the PC on. To do this, follow the instructions below.
CHAPTER 1 Washingtons (01-10) 9/12/12, 10:45 AM6