Filter
Top Products
5 Broadcom Advanced Control Suite 2 (BACS2) 191
E
Deleting a VLAN
To delete a VLAN, right-click the VLAN and select "Remove VLAN".
1 Click the "Tools" menu → "Configure a Team".
If there is more than one team, click the name of the team that has the VLAN you want to
delete, and then click [OK].
2 Click [Remove VLAN].
3 Click [Apply].
Click [Yes] when the message is displayed indicating that the network connection will be
temporarily interrupted.
` If you delete a team, any VLANs configured for that team are also deleted.
Configuring LiveLink for a Smart Load Balancing and Failover Team
Read the following notes before you attempt to configure LiveLink.
` Before you begin configuring LiveLink™, review the description of LiveLink. Also verify that
each probe target you plan to specify is available and working. If the IP address of the probe
target changes for any reason, LiveLink must be reconfigured. If the MAC address of the
probe target changes for any reason, you must restart the team. (J"4.8.10 Troubleshooting
Teaming Problems"(pg.147).
` A probe target must be on the same subnet as the team, have a valid (not a broadcast,
multicast, or unicast), statically-assigned IP address, and be highly available (always on).
` To ensure network connectivity to the probe target, ping the probe target from the team.
` You can specify up to four probe targets.
` The IP address assigned to either a probe target or team member cannot have a zero as
the first or last octet.