Filter
Top Products
5
D The installation is started.
D The Cardiris installation window appears.
10.
Scroll down and read the "License" to the
end. Then, click the [Continue] button.
D A confirmation message window appears.
11.
Click the [Agree] button.
D The [Select Destination] window appears.
D By default, Cardiris is installed in the
Applications Folder.
12.
Click the [Continue] button.
D The [Installation Type] window appears.
13.
Confirm that [Easy Install] is specified in
the [Installation Type] pop-up menu.
14.
Click the [Install] button.
D The installation is started.
D The [Finish Up] window appears.
15.
Click the [Quit] button.
D The [Startup item registration] window
appears.
16.
Click the [OK] button.
D When the installation is complete, the
[Installation completed successfully] window
appears.
17.
Click the [Close] button.
18.
Remove the Setup DVD-ROM from the
DVD-ROM drive.
D Software installation is complete. Proceed to "Con-
necting the ScanSnap" (page 5).
Connecting the ScanSnap
Connect the ScanSnap after the desired software has
been installed.
1. Select the power cable type according to
power source for the ScanSnap.
z To use the ScanSnap at a fixed location
Use the power cable (*) to connect to an AC out-
let.
For details about the connection, refer to "Using
the Power Cable" (page 6) in Step 3.
*: Combination of the AC adapter and AC cable
z To use the ScanSnap in a remote location with
your laptop computer or a place without AC
outlets available nearby
Use the USB bus power cable for power supply
from your computer.
For details about the connection, refer to "Using the
USB Bus Power Cable" (page 6) in Step 3.
2. Remove the tape seal covering the USB
connector and power connector of the
ScanSnap.
To install only ScanSnap Manager, click
the [Customize] button to show the
[Custom install on "(volume_ name)"]
window, and clear the [ABBYY
FineReader for ScanSnap] and
[Cardiris] checkboxes.
You cannot install "ABBYY FineReader
for ScanSnap" or "Cardiris" only.
Only one ScanSnap can be connected to a
computer at a time.
CAUTION
Do not use AC adapters other than the one
supplied with this ScanSnap. Doing so may
cause damage to the ScanSnap.
Manufacturer: LEI
Model No.: NU13-1072166-I3
AC Cable
AC
Adapter
USB Bus
Power Cable