Filter
Top Products
5-10 SPARC Enterprise T1000 Server Service Manual • April 2007
3. Get the dual-drive cable that was shipped with the new drive assembly.
4. Plug the drive connectors into the data/power connectors at the rear of the hard
drives.
Note – Make sure the connector is correctly oriented before plugging it into the
data/power connector on the drives. When connecting the cable to the data/power
connector on the lower drive in a dual-drive configuration, it may be easier to first
remove the upper drive to get a clear view of the data/power connector on the
lower drive.
■ If you have a single-drive assembly, plug the DRIVE 0 connector into the
data/power connector at the rear of the drive.
■ If you have a dual-drive assembly, make the following connections to the two
drives:
■ Plug the DRIVE 0 connector into the data/power connector on the lower drive.
■ Plug the DRIVE 1 connector into the data/power connector on the upper drive.
5. Slide the drive assembly into the chassis until it mates with the front of the
chassis.
FIGURE 5-8 shows a dual-drive assembly being inserted into the chassis. The process
is the same for a single-drive assembly.
FIGURE 5-8 Installing the Drive Assembly
Fasteners