Filter
Top Products
5
General monitor settings
Freeze frame
This function, when activated, freezes the image
on the screen, disregarding the input signal until
deactivated.
Source information
This setting allows the user to disable the source
information that appears on the upper left hand
corner each time a source is detected or Input
key is pressed. Always use On state.
OSD timeout
Choose how much time the GUI will remain
displayed on the screen when no control is being
used. When the user is not touching the monitor
controls, this timer will, after the selected period of
time, remove the GUI from the screen.
Logo timeout
Choose how much time the logo will remain on
the screen when the display is powered. The
"Disabled" option will make the display skip the
logo display at start up.
Monitor timeout
Choose how much time the monitor will remain
powered when the user is not touching its
controls. The "Disabled" setting disables this
feature. After the selected time has passed and
the user has not touched the monitor controls, it
will automatically power off. Set to "Disabled" for
radar/ECDIS.
Monitor address
Choose to which address the monitor should
respond when ECDIS commands are detected
over the serial link.
Serial mode
Choose what kind of serial bus is connected to
the monitor. Use the default setting (RS 232).
Monitor to monitor
Choose whether the display initiates an ECDIS
transmission towards the other displays
connected to it when the user tries to adjust the
backlight level. In "Slave" mode, the monitor
never initiates ECDIS transmissions on its own. In
"Master" mode, the monitor issues an ECDIS
command over the serial link each time the
backlight is changed. This function is only
available if serial mode is set to 422 or 485.