Filter
Top Products
8
Main screen acquisition settings
This menu is available when PIP is set to ON.
(See next page.)
Mode selection
Choose a memory slot in which to store
display parameters for a given input signal.
Once stored in a memory slot, the settings for
the current input signal can be modified at will,
and they will be reapplied when the same
source is detected again.
Mode details
This box shows what's inside the memory slot
selected with the Mode selection setting.
Load current mode
This stores the settings detected by the image
processor for the current signal in the memory
slot selected with the Mode selection setting.
Once the detected parameters have been
stored in memory, they can be edited by the
user with the controls described below.
Clear
Press this key to delete the contents of the
selected memory slot. Once the content of a
given slot has been deleted, it is lost and
cannot be retrieved.
H. total
Adjust the frequency of the clock signal used
to drive the analog to digital converter that
samples the input signal.
Phase
Adjust the phase of the clock used to drive the
analog to digital converter that samples the
input signal.
H. res. and V. res.
By means of this setting, the user is able to
force the image processor into detecting the
current signal with a given horizontal or
vertical resolution.
H. pos. and V. pos
These two settings allow the user to move the
input signal around on the main screen, so it is
displayed correctly in its entirety.