Filter
Top Products
1
Introduction
Installation of the USB Data Card Programmer and
Device Drivers
1. Connect the USB connector on the end of the Programmer cable to
the USB port on the back of the computer. Most computers have two
USB Ports. Either port will work. The computer does not need to be
turned off when connecting or dsconnecting the Programmer.
Use care to insert the USB connector correctly. Do not force the
connection as this may damage the USB port on your
computer or the USB connector on the Programmer.
Installation
USB
(Universal Serial Bus)
Port
and USB Connector
Connecting the Programmer to
Your Computer
After connecting the Programmer to your computer you must install
the device drivers from the CD-ROM provided with the Programmer.
2. Insert the Programmer CD-ROM into your computer’s CD-ROM
drive.
3. The computer will recognize the Programmer as a USB device and
open the Add New Hardware Wizard and search for the device drivers.
Click on “Next”. If, for some reason, the Wizard does not run
automatically, click the Start button and select “Settings” and then
“Control Panel”. Double click on the “Add New Hardware” icon.
4. The next screen will ask you if you want it to search for the best
driver for your device or if you want to display a list to choose
from. Select “Search for the best driver for your device” and click
on “Next”.
Installing the Device Drivers
USB Connector
USB Port
Programmer Cable