Filter
Top Products
3
Installation
Installing a Data Card in the
Programmer
To Install a GARMIN Data Card:
1. Insert the Data Card (Label up and pin connector end first) into the
card slot in the Programmer (picture to the right).
2. Be certain to install the Data Card completely into the slot to be
certain pin connections have been made.
3. To remove the Data Card, pull directly away from the Programmer
using the extractor handle on the Data Card.
Use care not to remove the Data Card from the Program-
mer until data transfer has been completed to avoid
possible loss of data.
Data
Card
Extractor Handle
Card Slot
Disconnecting the Programmer
from Your Computer
Disconnecting the Programmer from Your Computer
After the USB Data Card Programmer has been successfully
installed (hardware and software), disconnecting and reconnecting the
Programmer can performed without additional installation steps.
1. Before disconnecting the Programmer, be certain that no data
transfer is in progress.
2. Unplug the USB connector from your computer. You do not need to
turn the computer off before removing or inserting the USB
connector.