Filter
Top Products
Magnum 6K8-Series Industrial Field Switch Installation and User Guide 03/06)
33
www GarrettCom com
..
The Magnum 6K8-Series chassis consists of top cover and bottom
chassis assembled together with the help of 12 Philips-head screws. There are 4 screws
located on the top-side panel of the unit
(2 each on both side), 8 for bottom
chassis base of the unit. Remove these
screws. Once these screws are removed,
the top-cover is easily slide out to the
front, off the chassis base, as shown in
the picture above in Fig. 3.6.1a.
Figure 3.6.1a: Removing the Top
panel from the Chassis base of the
unit
Caution: Be careful not to disturb the power supply.
When the chassis top cover has been removed, the interior of the unit is
exposed. Looking down into the Magnum 6K8-Series unit, notice that there are PM
module installed and daughter module would be facing your eyes on the top installed on
the main board with J5 and DSSV pins connected on the right. (See Figure 3.6.1b)
below.
Figure 3.6.1b:
Magnum 6K8-Series,
Top view without
chassis cover w/
daughter module on the
top.
Note: Un-hooked the J5and DSSV connected wires first as shown in Figure above
with arrow mark.
Step 3. Remove front panel face plate
retaining screws and screen plate
There are four retaining screws as shown with
arrow mark in Fig 3.6.1c holding the face plate of
the chassis.
Figure 3.6.1c: Top View – 6KPM retaining screws hold Face Plate
Dau
g
hter boar
d
Power LED, Pin J5
Power Supply, Pin DSSV