Filter
Top Products
Module (RPM) to provide either 10BASE2, 10BASE5, 10BASE-FL, FOIRL, or 10BASE-T
connectivity. The individual RPMs are used for one Ethernet segment each, and provide full
IEEE 802.3 repeater functionality supporting a full length segment. Individual RPMs are
equipped
with a single media interface
connector. Any RPM can be
installed in either slot of the
Magnum 200X chassis.
Figure 2.2.1: Magnum 200X
To simplify media connections, each media interface port is accessible from the
front of the unit. All LEDs common to the 200X unit and all individual port LEDs are
front-mounted. No rear access is required except for the AC power cord.
The internal power supply is auto-ranging to handle any AC power type
worldwide. Power input may range from 90 to 260 vac, with a frequency rating of 47 to 63
Hz. The unit is equipped with a rear mounted IEC-type recessed male AC power
connector. (When shipped for use in areas other than 115 vac, a power cord will not be
included). The 200X unit is convection-cooled for silent operation.
The Magnum 200X base unit features Power (PWR), Receive (RX), Collision
(COL), and Jabber (JAB) LED status indicators located in the front of the unit. These
LEDs provide a visual assessment of the operational condition and aggregate network
activity at the unit, and are in addition to the LEDs on each individual RPM.
2.3 Magnum 200X - Repeater Port Modules (RPMs)
For standard 200X models, there is an option of four different Repeater Port
eu
Magnum 200X
GARRETT
PWR RX COL JAB