Filter
Top Products
Setting up the optional stand www.gateway.com
8
Adjusting monitor height tension
The stand is factory adjusted to maintain the height for your monitor. However,
if it does not stay in place when you let go, you need to change the stand’s
height tension. You also need to adjust the stand if the amounts of force
required to raise and lower the monitor are not equal.
To adjust your monitor’s height tension:
1 Press the screwdriver access hole cap from below the base to remove it
from the base.
2 Insert a Phillips screwdriver through the access hole in the base and onto
the height tension screw (on the back of the stand, in the slot above the
USB In port).
3 Adjust the height tension screw so the monitor stays in place when you
let go. If the monitor lowers by itself when you let go, turn the screw
clockwise several complete turns. If the monitor rises when you let go, turn
the screw counter-clockwise several complete turns. You may need to turn
the screw several times before the tension is correct for your size of
monitor.
Screwdriver access cap
Height tension screw
8511654.book Page 8 Monday, July 24, 2006 11:00 AM