Filter
Top Products
Adjusting the stand
www.gateway.com
5
Rotating the screen image
Depending on the graphics card or device driver on your computer, you may
be able to rotate the on-screen image.
To rotate the screen image:
■ On Gateway computers, you can rotate the image by pressing
C
TRL+ALT+[LEFT ARROW], and return it to normal by pressing
Ctrl+Alt+[
UP ARROW].
For more information, click Start, Control Panel, Appearance and
Themes (if necessary), Display, the Settings tab, Advanced, then click the
graphics card-specific tab.
Adjusting monitor height tension
The stand is factory adjusted to maintain the adjusted height for Gateway
17-inch and 19-inch flat-panel monitors. If you use this stand with a lighter
monitor without adjusting the weight setting of the stand, the stand will raise
your monitor, and if you use a heavier monitor, the stand will lower your
monitor.
To test and adjust your monitor’s height tension:
1 Move your monitor up and down through its entire vertical range. If it does
not stay in place when you let go, you need to change the adjustable
stand’s height tension. You also need to adjust the stand if the amounts
of force required to raise and lower the monitor are not equal.
2 Adjust the height tension screw so the monitor stays in place when you
let go. If the monitor lowers by itself when you let go, turn the screw
clockwise several complete turns. If the monitor rises when you let go, turn
the screw counter-clockwise several complete turns. You may need to turn
the screw several times before the tension is correct for your monitor.
Increase lifting tension
(clockwise)
Decrease lifting tension
(counter-clockwise)
8511460.book Page 5 Thursday, April 6, 2006 2:32 PM