CHAPTER 1: Using Your Gateway Flat-Panel Monitor
2
Connecting the monitor
To set up the monitor, first attach the base, then make your cable connections.
Attaching the base
To attach the base:
1 Slide the monitor’s neck onto the base.
2 Place the monitor face-up on a stable surface. A non-slip mat on a tabletop is ideal. Let
the monitor neck hang down over the edge of the table.
3 Slide the neck onto the base.
4 Tighten the thumbscrew with your fingers (or a flat screwdriver) under the base to secure
the neck into place.
Thumbscrew
8512088.book Page 2 Friday, January 12, 2007 3:31 PM