61
BIOS Beep Codes
BIOS Beep Codes Table
PEI Beep Codes
# of Beeps Description
1 Memory not Installed.
1 Memory was installed twice (InstallPeiMemory routine in PEI Core called twice)
2 Recovery started
3 DXEIPL was not found
3 DXE Core Firmware Volume was not found
4 Recovery failed
4 S3 Resume failed
7 Reset PPI is not available
DXE Beep Codes
# of Beeps Description
1
Invalid password
4
Some of the Architectural Protocols are not available
5
No Console Output Devices are found
5
No Console Input Devices are found
6
Flash update is failed
7
Reset protocol is not available
8
Platform PCI resource requirements cannot be met
BIOS Recovery Instruction
AMI has an embedded recovery technique. In the event that the BIOS becomes corrupt the boot block can be used to
restore the BIOS to a working state. To restore your BIOS, please follow the instructions listed below:
Recovery Instruction:
1 Prepare a bootable handy drive or floppy diskette
2 Copy the image file to the bootable hand drive or the bootable floppy diskette.
3 Rename the image file to "FLASHABL.ROM".