Filter
Top Products
2-4
CHAPTER 2
port, one parallel printer port, as well as two antennas on
the rear panel.
zThree RJ-45 ports for connection to a 10BASE-
T/100BASE-TX Ethernet Local Area Network (LAN).
These ports can auto-negotiate the operating speed to
10/100 Mbps, the mode to half/full duplex, and the pin
signals to MDI/MDI-X (i.e., allowing these ports to be
connected to any network device with straight-through
cable). These ports can be connected directly to a PC or to
a server equipped with an Ethernet network interface card,
or to a networking device such as an Ethernet hub or
switch.
zOne RJ-45 port for connection to an xDSL or Cable
modem. This port is fixed at 10 Mbps, full duplex.
zOne RS232 serial port to connect to an ISDN Terminal
Adapter (TA) or to a PSTN analog modem.
zOne parallel printer port that can be connected to a printer,
which can be shared by any LAN/WLAN users.
zTwo antennas.
The following figure shows the components of the
Gateway: