GateWay Fax Systems 90SI Fax Machine User Manual


  Open as PDF
of 33
 
GateWay Fax Systems, inc. Model 90si Secure Fax Gateway User's Guide
www.gwfs.com, 877-951-9800, info@gwfs.com help line: 877-951-9814 page 13
Entering the Default Settings mode is done with the Secure Telephone / Crypto idle (not in Secure Data mode) by
pressing and holding the Reset button on the side of the 90si for ve (5) to six (6) seconds until both Green and
Red lights extinguish. Releasing the Reset button at this point will place the 90si into the Default Settings mode
as evidenced by the Green light extinguished and the Red light illuminated. Changing the default protocol is then
done using the attached fax machine's handset (or Hook button) and dial pad by dialing the two-digit code(s) of
the setting(s) you wish to turn on or activate. The Secure Telephone / Crypto should be idle (not in Secure Data
Mode). After dialing the two-digit code(s), hang up the fax to exit the Default Settings mode. The Green light will
blink a number of times and then illuminate steadily. The 90si is now ready to operate with your new Default Set-
tings.
The following example shows how to change the default conguration to 2-Line Dual-Mode (dened as congu-
ration # 03)...
With the Secure Phone idle (not in Secure Data mode) and only the Green "Power" light illuminated
Procedure Response
Press and hold
the Reset button
on the 90si
... until both the Green and Red lights extinguish, then...
release Reset the Green light will be extinguished and the Red light illuminated
Take the fax off-
hook *1
(you will hear dial-tone)
Press 0 and then
3 on the fax dial
pad
you will hear a beep. (Note: 03 is the conguration code for 2-Line Dual-
Mode. See the above Default Settings list for Secure Only, and 1-Line
Dual-Mode.
hang up the fax The Green light will blink a number of times. When it illuminated steady
the 90si will now be ready and in the 2-Line Dual-Mode conguration.
Notes:
*1 Most fax machines have a button that when depressed, returns dial-tone from the telephone system. This
button is often labeled Hook, Manual Dial, Monitor, On Hook Dial or something to that effect. Find and use this
Hook button on your fax or use the handset. If your fax does not have a handset or a hook button you will need to
temporarily connect a plain old telephone to the TEL jack on the back of the fax machine to change Default Set-
tings.
25 Print the Default Settings List
Currently this feature is unavailable but will be provided to you, at no charge, in a future remote software up-
grade.
The factory Default Settings List is printed from the 90si to the attached COTS fax and looks like this.
90si Default Settings List:
Conguration (select one)
->(01)<- Secure Only (factory default)
(02) 1-Line Dual-Mode
(03) 2-Line Dual-Mode
Mode (select one)
(04) Half Duplex
->(05)<- Full Duplex
Protocol (select one)
(06) Async 2400 Bd
 previous next