Filter
Top Products
Installation Instructions
INSTALL THE FAUCET (CONT.)
6. Feed the water tube up through the faucet base.
Then push the tube into the fitting on the bottom
of the faucet body. It should go in about 3/4″.
Pull tube slightly to make sure it is secure.
7. Push the faucet body down into the faucet base
and twist clockwise until it clicks into place.
NOTE: You can install the faucet so the handle
is on the right or the left side.
If you want the faucet handle on the right,
position the handle at the back of the faucet
base before turning clockwise.
If you want the faucet handle on the left,
position the handle at the front of the faucet
base before turning clockwise.
7. Locate the hole at the rear of the base. Insert
set screw and begin to tighten by hand. Finish
tightening with the allen wrench provided
in the packet.
Faucet Body
Base
Sink
Gasket
Butterfly Bracket
Faucet Faucet
Faucet handle on the RIGHT Faucet handle on the LEFT
10