Filter
Top Products
1
Influent challenge levels are average influent concentrations determined in surrogate
qualification testing.
2
μg/L means Micrograms Per Liter.
3
Maximum product water level was not observed but was set at the detection limit
of the analysis.
4
Maximum product level is set at a value determined in surrogate qualification testing.
5
Chemical reduction percent and maximum product water level calculated at chloroform
95% breakthrough point as determined in surrogate qualification testing.
6
The surrogate test results for heptachlor Epoxide demonstrated a 98% reduction. These data
were used to calculate an upper occurrence concentration, which would produce a maximum
product water level at the MCL.
Organic Chemicals Reduced by Chloroform Surrogate Testing
Avg.
1
Influent Max. Effluent
Contaminant (μg/L)
2
(μg/L)
2
Alachlor 50 1.0
3
Atrazine 100 3.0
3
Benzene 81 1.0
3
Carbofuran 190 1.0
3
Carbon Tetrachloride 78 1.8
4
Chlorobenzene 77 1.0
3
Chloropicrin 15 0.2
4
2,4-D 110 1.7
4
Dibromochloropropane (DBCP) 52 0.02
3
o-Dichlorobenzene 80 1.0
3
p-Dichlorobenzene 40 1.0
3
1,2-Dichloroethane 88 4.8
5
1,1-Dichloroethylene 83 1.0
3
cis-1,2-Dichloroethylene 170 0.5
3
trans-1,2-Dichloroethylene 86 1.0
3
1,2-Dichloropropane 80 1.0
3
cis-1,3-Dichloropropylene 79 1.0
3
Dinoseb 170 0.2
4
Endrin 53 0.59
4
Ethylbenzene 88 1.0
3
Ethylene Dibromide (EDB) 44 0.02
3
Haloacetonitriles (HAN):
Bromochloroacetonitrile 22 0.5
4
Dibromoacetonitrile 24 0.6
4
Dichloroacetonitrile 9.6 0.2
4
Trichloroacetonitrile 15 0.3
4
Avg.
1
Influent Max. Effluent
Contaminant (μg/L)
2
(μg/L)
2
Haloketones (HK):
1,1-dichloro-2-propanone 7.2 0.1
4
1,1,1-trichloro-2-propanone 8.2
6
0.3
4
Heptachlor (H-34, Heptox) 80 0.4
3
Heptachlor Epoxide 10.7
6
0.2
6
Hexachlorobutadiene 44 1.0
3
Hexachlorocyclopentadiene 60 0.002
3
Lindane 55 0.01
3
Methoxychlor 50 0.1
3
Pentachlorophenol 96 1.0
3
Simazine 120 4.0
3
Styrene 150 0.5
3
1,1,2,2-Tetrachloroethane 81 1.0
3
Tetrachloroethylene 81 1.0
3
Toluene 78 1.0
3
2,4,5-TP (silvex) 270 1.6
3
Tribromoacetic acid 42 1.0
3
1,2,4-Trichlorobenzene 160 0.5
3
1,1,1-Trichloroethane 84 4.6
4
1,1,2-Trichloroethane 150 0.5
3
Trichlorothylene 180 1.0
3
Trihalomethanes (includes): 300 15
Chloroform (surrogate chemical)
Bromoform
Bromodichloromethane
Chlorodibromomethane
Xylenes (total) 70 1.0
3
Testing was performed under standard laboratory conditions; actual performance may vary.
NOTE: Substances reduced are not necessarily in your water. Filter must be maintained according to manufacturer’s instructions, including replacement of filter cartridges.
WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst
reduction may be used on disinfected waters that contain filterable cysts.
Performance Data Sheet.
7