Filter
Top Products
PB3-POS-RP ProBridge
User Manual
28
Hyperterminal Setup
Manual configuration can also be completed using Windows
HyperTerminal in stead of the DIP switches. Manual
configuration should only be used if the “POS Device Selection”
does not conform to your specific device because baud rates or
protocols are slightly different than the default values for the
selected device.
Equipment Required
You will need the following equipment to program the PB3 using
HyperTerminal:
• A PC or Laptop Computer with a COM port and
Windows 98/NT/200/XP installed and operational.
• The supplied 4310-0047B PB3 to PC (DB9F to RJ45)
cable.
Setup
1. Remove power and disconnect the PB3 from the
DVMRe.
2. Plug the 4310-0047B cable into Port 1 of the
PB3 and a free COM port on your PC, typically
COM1.
3. Launch HyperTerminal, found in
Start/Programs/Accessories/Communications/
HyperTerminal.