Filter
Top Products
Page 4
Operation
Screen Display ON/OFF
1. Press the PWR button.
2. To turn off the POWER, press the PWR button again.
Note:
If properly connected, the monitors main POWER will turn off when the vehicle’s
ignition switch is off. If the main power lamp illuminates in the STAND BY mode, the
vehicle’s battery may be discharged.
Adjusting the Volume
1. Adjust the volume level by pressing the DN or UP button.
Switching NTSC/PAL
Switch the movie output type NTSC/PAL in AUX mode.
1. Press the DISP button for at least 1 second.
Note: When the movie output type is not compatible, the movie does not output
normally.
Switching the source
1. Press the SEL button. Each press of the button will cycle through the modes as
follows:
Switching the display mode.
1. Press the DISP button.
Each press of the button will cycle through the modes as follows:
WIDE: Normal images are expanded uniformly in the horizontal direction and are
displayed over the entire screen.
CINEMA: Normal images are expanded in the horizontal and vertical directions.
The top and bottom of the image is cut off. This mode is suited for 16:9 cinema size
images.
ZOOM: Normal images are expanded in the horizontal direction and are displayed
over the entire screen. The expansion ratio increases towards the right and left
edges of the screen.
NORMAL: Normal image (4:3)
Main power indicator
PWR
UP
DN
SEL
DISP
Remote control sensor
(The remote control is
sold separately)
NOTE: Controllable with Remote Control
This unit can be controlled with an optional Alpine remote control. For details, consult your Alpine dealer. Point
the optional remote control transmitter at the remote control sensor.
AUX
NAVIGATION
WIDE ZOOM
CINEMA
NORMAL