Filter
Top Products
■■
GE Zenith Controls 1
■■
ZTX Operation and Maintenance Manual (62
R-2000)
How to Remove the Cover
DANGER
HAZARDOUS VOLTAGE
Will shock, burn or cause death.
Do not remove cover until ALL
power is disconnected.
Re-installation of cover is required
after maintenance or service.
Loosen but do not remove four cover screws. Lift cover
off the four screws and hang on two screws (2 bottom
or 2 right-hand). See Figure i and ii.
This will prevent damage to the cable. The cable may
also be disconnected at the controller or keypad.
Figure i
Figure ii
NOTE: Reattach cable before installing cover.