Filter
Top Products
■■
GE Zenith Controls 5
■■
ZTX Operation and Maintenance Manual (62
R-2000)
Installation
(cont’d)
DANGER
HAZARDOUS VOLTAGE
(Can Cause Severe Injury or Death)
Turn OFF all power before installation, adjustment, or removal of transfer switch or any of its components.
ATTENTION!
This applies only to the switches with the RM4-CAT
exerciser option:
Upon installation, connect the MX50/90 controller to a
9V battery (not supplied) via the harness that is con-
nected to the controller. The battery should be placed
in the holder installed just above the controller. This is
to ensure that the setting in the exercisor clock are
retained in the event of power outage. The battery
should be replaced once a year. If the battery is not
installed and/or replaced as recommended, the
exerciser clock will lose its settings and the exerciser
will not work.
Should the harness become disconnected in shipping,
take the controller cover off and plug the harness in the
receptacle in the top right corner of the MX controller.
Reinstall the cover and connect the battery.
Battery and Holder
Battery Harness
MX50/90 Controller