Filter
Top Products
14
ADJUSTING THE 4X4 COMPONENT MATRIX OVER CAT-5 RECEIVER
Each 4x4 Component Matrix Over CAT-5 Receiver has two trim pots used to
adjust the brightness and focus of the video output. These adjustment trim pots
are located on the front panel of each unit. Please use the guidelines below for
adjusting both trim pots.
Brightness
If the image appears too dim or too bright, adjust the brightness trim pot.
Insert a small fl athead adjustment tool into the trim pot.1.
Turn the trim pot in a clockwise fashion until the trim pot stops turning. Do 2.
not force the trim pot beyond this point as it may break and will render the
trim pot useless.
Turn the trim pot in millimeter increments in a counter-clockwise fashion until 3.
the desired brightness is reached.
Remove the trim pot adjustment tool.4.
Focus
If the image is out of focus, or the colors are smeared, adjust the focus trim pot.
Insert a small fl athead adjustment tool into the trim pot.1.
Turn the trim pot in a clockwise fashion until the trim pot stops turning. Do 2.
not force the trim pot beyond this point as it may break and will render the
trim pot useless.
Turn the trim pot in millimeter increments in a counter-clockwise fashion until 3.
the desired focus is reached.
Remove the trim pot adjustment tool.4.