Filter
Top Products
7
Locking 5V DC Power Supply Input1
When using a 5 BNC cable system this connector will not need to be used.
When using a 4 BNC cable system a second 5V DC power supply (part# EXT-
PS52AU) must be purchased and connected to this input port.
IR Receiver2
This receiver is used for the IR Repeater feature. This receiver will accept
standard IR remote commands for transmission back to the sending unit and
then to the connected IR emitter/blaster.
HDMI Output Port3
Connect the HDMI capable display device to this output port. A secure
connection to this HDMI port can be made using Gefen Mono•LOK cables.
IR Extension Port4
An IR receiver extension (sold separately, part# EXT-RMT-EXTIR) can be
connected to this port to relocate the IR receiver. This option is available so that
the receiving unit can be placed out-of-sight while still retaining the usability of
the IR Repeating feature.
Link LED Indicator5
This LED indicator will become active once a valid link has been established
between the sending and receiving units. If this LED does not activate there is a
possible mis-connection between the two units.
Red BNC Connector6
This connector will transmit the RED signal data to the receiving unit. The cable
used for this connection cannot be omitted.
Green BNC Connector7
This connector will transmit the GREEN signal data to the receiving unit. The
cable used for this connection cannot be omitted.
Blue BNC Connector8
This connector will transmit the Blue signal data to the receiving unit. The cable
used for this connection cannot be omitted.
Clock BNC Connector9
This connector will transmit the CLOCK signal data to the receiving unit. The
cable used for this connection cannot be omitted.
Receiver Power BNC Connector10
This connector will transmit the power needed to operate the receiving unit. The
cable used for this connection can be omitted when using a 4 BNC type of cable
setup. If this cable is omitted power must separately be supplied to the receiver
by one of the included 5V DC power adapters.
RECEIVER PANEL DESCRIPTIONS